Several months back I did a series of military emblems. I never finished the Air Force emblem for various reasons. I promised several readers back then that I would eventually try to complete the series. Tonight I finished.
There will be a bit of a challenge to cut the letters out of the center board. Some of them are pretty small an will require a small blade. A #1 or a #2/0 should do the trick.
The emblem is a sandwich of three layers. A plain backer board, a center board with the letters cut out of it then all the ornamentation is applied to the middle layer. After you get the letters cut the rest should be pretty easy. I don't have time right now to do a test cut. If any of you give this pattern a try I would appreciate feedback on any problems.
Make A Donation