This fretwork vase is 7.5 inches tall. After I cut this sample I did go back and make one change. I think I would like it better if the back of the vase did not have fretwork. I don't like how the back cuts show through. I think it is distracting. I'll leave it up to you to make it the way you like.
I used 1/4" Thick walnut. There are instructions in the pattern on how to assemble. The one thing I want you to watch for are the sides. The angle causes the bottom not to be flat. You could cut the sides to the angle on your table saw. I find it easier to just let the sides over hang while gluing and flatten them at the end on my disk sander. The instruction show this process and an alternative.
The Scrollsaw Workshop is primarily supported by donations. If you enjoy this Blog and would like to make a donation please click this link. Your support is greatly appreciated.
Make A Donation
If you would like to have all the patterns in the Scrollsaw Workshop catalog you can buy the first six years
DVD and the 2013 update DVD at this link. DVD #1 is $20 and contains over 1,100 patterns. The 2013 update DVD is $7.50 and has another 178 patterns.
